Installing Memory Modules - IBM 8676 - Eserver xSeries 335 Installation Manual

Installing memory modules

This section describes how to install memory modules in the server. Before you
install memory modules, review the following information:
v The xSeries 335 Type 8676 server uses interleaved dual inline memory modules
v You can increase the amount of memory in the server by replacing them with
Complete the following steps to install DIMMs:
1. Review the safety information beginning on page v, and "Installation guidelines"
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. Remove the server cover (see "Removing the cover and bezel" on page 8).
(DIMMs), which requires that you add, remove, or replace DIMMs in pairs. Each
pair must be of the same type, capacity, and speed. Adding memory to the
server is an easy way to improve system performance. The server comes with
one pair of DIMMs installed in DIMM slots 1 and 2 on the system board.
higher-capacity DIMMs or installing an additional pair of DIMMs in slots 3 and 4.
The server supports 256 MB, 512 MB, and 1 GB DIMMs. See the ServerProven
list at http://www.ibm.com/pc/compat/ on the World Wide Web for a list of
memory modules supported by the server. The following illustration shows the
memory slots on the system board.
on page 7.
cords; then, disconnect all external signal cables from the server.
DIMM 4 (J37)
DIMM 3 (J35)
DIMM 2 (J34)
DIMM 1 (J32)
Chapter 2. Installing options
15