Intel SE7500WV2 - Server Chassis - SR2300 Product Manual page 55

12. Lift the fan end of the power supply above the chassis standoff and slide it toward the front of
the server (D). Lift the power supply out of the chassis (E).
13. Place the new power supply in the chassis and slide it to the rear as far as it will go.
14. Install the two screws at the rear of the chassis and the one screw at the fan end of the power
supply.
15. Plug the main power connector into the server board.
16. Connect all other power cables to their devices.
17. Install the fan module and connect the fan power cables to the server board.
18. Install the full-height PCI riser card.
19. Route and connect all cables.
CAUTION
Carefully route cables in their original paths to minimize airflow blockage
and cooling problems.
20. Install the chassis cover.
21. Connect the power cord(s) to the power cord receptacle(s) and plug the cord(s) back into the
power source.
Working Inside Your Server 55