Dodge 2007 Sprinter Owner's Manual page 28

Always have seats belts that are damaged or
have been subjected to a heavy load in an
accident replaced, and their anchorages
checked, at a qualified specialist workshop
which has the necessary specialist knowl-
edge and tools to carry out the work re-
quired.
The manufacturer recommends that you use
an authorized Sprinter Dealer for this pur-
pose. In particular, work relevant to safety
or on safety-related systems must be car-
ried out at a qualified specialist workshop .
For safety reasons, the manufacturer rec-
ommends that you only use seat belts that
have been specially approved for your vehi-
cle by the manufacturer.
Wearing seat belts
1 Belt sash guide ( page 28)
2 Belt latch plate
3 Release button
4 Buckle
Pull the belt smoothly from the seat
belt reel holder.
Occupant safety
Route the belt over your shoulder.
Click belt latch plate 2 into buckle 4.
Adjust the belt to the correct height if
necessary.
Pull the shoulder section of the belt up-
wards to tighten the belt against your
body if necessary.
Adjusting the belt height
Warning
Only adjust the belt height when the vehicle
is stationary and the handbrake is applied.
You could otherwise lose control of the vehi-
cle as a result of the seat adjusting move-
ment and thereby endanger yourself and
others.
You can adjust the belt height for the fol-
lowing seats:
Driver's seat
Outer co-driver's seat
2
G