Console Port Mode 2 Signaling And Pinouts; Uplink Ports - Cisco WS-C6503 Manual

Appendix B Port, Cable, and Connector Specifications

Console Port Mode 2 Signaling and Pinouts

This section provides the signaling and pinouts for the console port in mode 2 (CONSOLE PORT MODE
switch in the out position). See
Table B-4
Console Port
Pin (signal)
1 (RTS)
2 (DTR)
3 (RxD)
4 (GND)
5 (GND)
6 (TxD)
7 (DSR)
8 (CTS)
1. Pin 1 is connected internally to Pin 8.

Uplink Ports

The Supervisor Engine 2, Supervisor Engine 32, Supervisor Engine 32 PISA, the Supervisor
Engine 720, Supervisor Engine 720-10GE, and the Supervisor Engine 2T all have Ethernet uplink ports
available on the front panel. These Ethernet ports can be used to provide additional port capacity for a
fully configured switch or can reduce the need to use a chassis slot for a Gigabit Ethernet module or
10-Gigabit Ethernet module where only a few Gigabit or 10-Gigabit Ethernet ports are required.
Table B-5
Table B-5
Supervisor Engine
Supervisor Engine 2
Supervisor Engine 32
(WS-SUP32-GE-3B and
WS-SUP32P-GE)
Supervisor Engine 32
(WS-SUP32-10GE-3B and
WS-SUP32P-10GE)
OL-7397-03
Table B-4
Console Port Pinouts (Port Mode Switch Out)
1
1
lists the supervisor engine model and the number and type of uplink ports available.
Supervisor Engine Uplink Ports
for the pinouts.
Console Device
Input/Output
Output
Output
Input
GND
GND
Output
Input
Input
Number of Type of Uplink Port
Uplink Ports
2 Two 1000BASE-X ports
(The two ports require GBIC transceivers.)
9 Eight 1000BASE-X ports (The eight ports
•
require SFP transceivers.)
One 10/100/1000 RJ-45 port (The port does
•
not require a pluggable transceiver.)
3 Two 10-GBASE-X (The two ports require
•
XENPAK transceivers)
One 10/100/1000 RJ-45 port (The port does
•
not require a pluggable transceiver)
Catalyst 6500 Series Supervisor Engine Guide
Uplink Ports
B-5