Cisco WS-C6503 Manual page 41

Chapter 2 Supervisor Engines
Table 2-8
LED
ACTIVE
PWR MGMT
DISK 0 (PCMCIA) LED
LINK
OL-7397-03
Supervisor Engine 32 Front Panel Status LEDs (continued)
Color and Meaning
The ACTIVE LED indicates whether the supervisor engine is
operating in active mode or is in standby mode.
Green—The supervisor engine is operational and active.
•
Orange—The supervisor engine is in standby mode.
•
The supervisor engine monitors each module's power requirements
and status relative to the system's overall power capacity before
fully powering up each module in the chassis.
Orange—Power-up mode; running self-diagnostics.
•
Green—Power management is functioning normally and
•
sufficient power is available for all modules.
Orange—A minor power management problem has been
•
detected. There is insufficient power for all modules to power
up.
• Red—A major power failure has occurred.
Green—The installed Flash PC card is being accessed and is
performing either a read or a write operation.
The LINK LED indicates the link status of the corresponding port.
For the eight SFP transceiver uplink ports plus the 10/100/1000
copper port, the LED colors indicate the following:
• Green—The port is active (the link is connected and
operational).
• Flashing orange—The port failed diagnostics and is disabled.
• Orange—The port is disabled.
• Red—The supervisor engine is resetting; an overtemperature
condition has occurred.
Note If the supervisor engine fails to download code and
configuration information successfully during the initial
reset, the LED stays red; the supervisor engine does not
come online.
Off—The port is not active or the link is not connected.
For LINK LEDs associated with the XENPAK transceiver uplink
ports, the LED colors indicate the following:
Green—The XENPAK transceiver is installed, a network
•
interface cable is attached, and a network link is established.
Orange—The XENPAK transceiver is installed, the network
•
interface cable is attached, but there is no network link
established.
Off—Either the uplink port socket is empty (no XENPAK
•
transceiver is installed) or the XENPAK transceiver is installed,
but does not have a network cable attached.
Catalyst 6500 Series Supervisor Engine Guide
Supervisor Engine 32
2-13