Cisco WS-C6503 Manual page 56

Supervisor Engine 720-10GE
Table 2-18 Supervisor Engine 720-10GE Features (continued)
Feature
Memory
Switch Processor DRAM
Route Processor DRAM
Switch Processor
Bootflash/Bootdisk
Route Processor Bootflash
CompactFlash (disk0)
Front panel features
Status LEDs
RESET switch
CONSOLE port
Universal Serial Bus (USB)
port
DISK 0 slot and LED
Uplink ports (PORT 1
through PORT 5)
Catalyst 6500 Series Supervisor Engine Guide
2-28
Description
1 GB
1 GB
1 GB
64 MB
Compact flash Type 2 (supports 64, 128, 256, 512 MB, and 1 GB
See Table 2-20 for a list of the status LEDs and their descriptions.
The RESET switch allows you to reset and restart the switch.
Because the reset switch is recessed in the faceplate, you must use a
Note
ballpoint pen tip or other small, pointed object to access the switch.
This is a 10/100/1000 port that uses an RJ-45 connector. The CONSOLE port
allows you to access the switch either locally (with a console terminal) or
remotely (with a modem). The CONSOLE port is an EIA/TIA-232
asynchronous, serial connection with hardware flow control.
Two USB 2.0 ports are provided. Currently, they are not enabled.
One PCMCIA slot is available. The PCMCIA slots allow a Flash PC card to
be installed providing additional flash memory. You can use this flash
memory to store and run software images or to serve as an I/O device. An
eject button is located on the left side, next to each slot. Pushing in on the
button ejects the Flash PC card from the slot. The slot supports 256 MB,
512 MB, and 1 GB Flash PC cards.
The PCMCIA slot has an LED associated with it.
Supervisor Engine 720-10GE has five uplink ports:
•
Two 10GBASE-X ports
–
Two 1000BASE-X ports
–
– One 10/100/1000BASE RJ-45 port
Note The two 10GBASE-X ports require X2 transceiver modules; the two
1000BASE-X uplink ports require SFP transceiver modules.
In chassis configurations where there are redundant supervisor
Note
engines installed, the uplink ports on the supervisor engine that is in
standby mode are fully functional.
Each uplink port has a link LED associated with it.
•
Chapter 2 Supervisor Engines
OL-7397-03