Cisco WS-C6503 Manual page 62

Supervisor Engine 2T
Table 2-22
Table 2-22 Supervisor Engine 2T Features
Feature
Chassis compatibility
Software requirements
(minimum)
Fan tray requirements
Slot installation restrictions
Hardware restrictions
Catalyst 6500 Series Supervisor Engine Guide
2-34
lists and describes Supervisor Engine 2T features.
Description
Supported only on all Catalyst 6500 E-series chassis.
12.2(50)SY
Both versions of the Supervisor Engine 2T require that a high-speed fan tray
be installed in the chassis.
Low-speed fan trays do not provide sufficient cooling for Supervisor
Note
Engine 2T.
Supervisor Engine 2T must be installed in:
Slots 1 and 2 in a 3-slot or a 4-slot chassis
•
Slots 5 and 6 in a 6-slot or a 9-slot chassis
•
Slots 7 and 8 in a 13-slot chassis
•
The primary supervisor engine can be installed in either slot.
Note
Note When the Supervisor Engine 2T is installed in a chassis with either
a WS-X69xx or a WS-X68xx module, there is a requirement that the
two slots adjacent to the supervisor engine and the module either
have a module installed in them or, if the slots are unused, have a
switching-module filler plate (Cisco part number SLOTBLANK-09
or WS-X6K-SLOT-CVR-E) installed for NEBS compliance. Do not
use blank slot covers (WS-X6K-SLOT-CVR) to cover the adjacent
unused slots.
Supported only in Catalyst 6500 E-series switches.
•
• Supports only modules equipped with the DFC4-A, DFC4-AXL,
DFC4-E, DFC4-EXL, or the CFC daughter cards. Modules equipped
with DFC3 daughter cards are not supported. For further information on
hardware restrictions and module support, refer to the software release
notes at the following URL:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2S
Y/release/notes/ol_20679.html
Chapter 2 Supervisor Engines
OL-7397-03