Required Tools; Installing A Supervisor Engine - Cisco WS-C6503 Manual

Required Tools

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 93
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into
Warning
beams or view directly with optical instruments. Statement 1051
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

Required Tools

These tools are required to install a supervisor engine in the chassis:
•
•
•
•

Installing a Supervisor Engine

This section describes how to safely install a supervisor engine.
To prevent ESD damage, handle the supervisor engine by the carrier edges only.
Caution
To install a supervisor engine in the chassis, follow these steps:
Step 1 Attach an ESD grounding strap to your wrist and to the ESD ground connector on the chassis or to a
properly grounded bare metal surface.
Note
Determine the correct slot for the supervisor engine. The supervisor engines must be installed in these
Step 2
slots:
•
•
Catalyst 6500 Series Supervisor Engine Guide
3-2
Small flat-blade screwdriver
No. 2 Phillips screwdriver
Antistatic mat to support an unpackaged supervisor engine
Your own ESD-prevention equipment or the disposable grounding wrist strap included with the
module
If you are unsure about the correct way to attach an ESD grounding strap, see the
Your ESD Grounding Strap" section on page C-1
Supervisor Engine 2
Slots 1 and 2 for all chassis
–
Supervisor Engine 32
Slots 1 and 2 for 3- and 4-slot chassis
–
Chapter 3 Installing Supervisor Engines
for instructions.
"Attaching
OL-7397-03