Cisco WS-C6503 Manual page 73

Chapter 3 Installing Supervisor Engines
Step 9 Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the
following two sets of steps:
Chassis with horizontal slots
a.
b.
Figure 3-1 Positioning the Supervisor Engine in a Horizontal Slot Chassis
Insert module
between slot guides
3
4
4
5
5
6
6
1
2
3
4
5
6
EMI gasket
Ejector lever fully
extended
OL-7397-03
Position the new supervisor engine in the slot. Make sure that you align the sides of the supervisor
engine carrier with the slot guides on each side of the chassis slot. (See
Carefully slide the supervisor engine into the slot until the EMI gasket along the top edge of the
supervisor engine makes contact with the module or cover plate in the slot above it and the
supervisor engine ejector levers have both closed to approximately 45 degrees with respect to the
supervisor engine faceplate.
EMI gasket
o
o
INPUT
FAN OUTPU T
OK OK
FAIL
INPUT
FAN
OUTPU T
OK OK
FAIL
Catalyst 6500 Series Supervisor Engine Guide
Installing a Supervisor Engine
Figure 3-1.)
3-5