Table of Contents
Advertisement
Chapter 3
Installing Supervisor Engines
–
–
Supervisor Engine 32 PISA
•
–
–
–
Supervisor Engine 720
•
–
–
–
Supervisor Engine 720-10GE
•
–
–
–
Supervisor Engine 2T
•
–
–
–
Note
Note
Visually verify that there is enough clearance to accommodate any interface equipment, such as
Step 3
pluggable transceivers, that you will install directly to the supervisor engine uplink ports.
If you are installing a Supervisor Engine 2T, verify that the two slots adjacent to the slot you are going
Step 4
to install the supervisor engine contain either another Supervisor Engine 2T, a module, or, if the slot is
unused, a switching-module filler plate (Cisco part numbers WS-X6K-SLOT-CVR-E or
SLOTBLANK-09).
Verify that the captive installation screws are tightened on all modules installed in the chassis.
Step 5
OL-7397-03
Slots 5 and 6 for 6- and 9-slot chassis
Slots 7 and 8 for 13-slot chassis
Slots 1 and 2 for 3- and 4-slot chassis
Slots 5 and 6 for 6- and 9-slot chassis
Slots 7 and 8 for 13-slot chassis
Slots 1 and 2 for 3- and 4-slot chassis
Slots 5 and 6 for 6- and 9-slot chassis
Slots 7 and 8 for 13-slot chassis
Slots 1 and 2 for 3- and 4- slot chassis
Slots 5 and 6 for 6- and 9-slot chassis
Slots 7 and 8 for 13-slot chassis
Slots 1 and 2 for 3- and 4- slot chassis
Slots 5 and 6 for 6- and 9-slot chassis
Slots 7 and 8 for 13-slot chassis
If you are installing a Supervisor Engine 2T in your chassis, the slots directly adjacent (above
and below in horizontal chassis or to the left and to the right in vertical chassis) to the supervisor
engine must contain either a redundant Supervisor Engine 2T, line cards or switching-module
filler plates (Cisco part numbers WS-X6K-SLOT-CVR-E or SLOTBLANK-09). If either slot is
going to remain unused and currently has a blank slot cover (Cisco part number
WS-X6K-SLOT-CVR) installed, you must remove the blank slot cover and replace it with a
switching-module filler plate for NEBS compliance.
The primary supervisor engine in a redundant supervisor engine configuration, or a single
supervisor engine configuration can be installed in either of the two slots.
Installing a Supervisor Engine
Catalyst 6500 Series Supervisor Engine Guide
3-3
Hide quick links:
Advertisement
Table of Contents
