HP N1200 - StorageWorks Network Storage Router User's And Service Manual page 84

Table 6 Fibre Channel status
SyncLosses is the number of times loss of sync. was detected.
BadRxChars is the number of bad characters received.
LinkFailures is the number of link failure conditions.
BadCRCFrames is the number of frames received with a bad CRC.
ProtocolErrs is the number of protocol errors detected.
BadSCSIFrames is the number of bad SCSI frames detected.
UnderflowErrs is the number of underflow errors detected.
Select A to have the status information repeatedly refreshed.
• Select 2 from the Fibre Channel Status menu to display Attached Fibre Channel Devices.
Figure 64 Fibre Channel device display
FC Port: 0
R) Refresh Device Display
D) Display Device Details
X) Return to previous menu
Command, <enter> for next FC Port > r
Port 0: Requesting discovery
Doing device discovery on port 0...
Completed discovery on port 0
Fibre Channel Device Display
FC Port: 0
Port 0: TARGET DEVICE (UP)
HP Ultrium 3-SCSI
R) Refresh Device Display
D) Display Device Details
X) Return to previous menu
Select R to refresh the device display (as shown in the menu above) with the latest status information
and perform manual FC discovery (as set in the Fibre Channel Configuration menu described earlier in
this chapter).
Select D to display device details.
• Select 3 to display FC Resource Status.
• Select 4 to display FC Driver Resource Status.
84 Using the Command Line Interface
Fibre Channel Device Display
X.XX.XX
07/7/2005
Port id: 0x000001
Version X.X XXXX
Port id: 0x000001
Port id: 0x000010
L22W Type: Direct Access
XXXXXX XXXXXXXXXXXXXXXX
08:56:22