Creating An Entry - HP N1200 - StorageWorks Network Storage Router User's And Service Manual

NOTE: Hi-Sup Bit is only set in an Active Fabric LUN which needs to be mapped as the first device (FC
LUN 00).
Select a number from the left column Num to add a device to the map. Selecting a device where LUN='-'
adds all LUNS for this target. If the selected device is already mapped, an error message appears to warn
the user about adding a duplicate device. N and P controls allow scrolling up and down the device list. X
brings the user back to the Edit Map Entries display table.

Creating an entry

The user can create an empty map, or use an existing map to pre-enter devices that are not yet online. To
perform this operation, the user has to know all the essential information about the device. A series of
questions are asked to guide the user through the process. The questions vary based on the current map
protocol.
The user is asked to:
• Select the LUN address for a device,
• The protocol/port on which device it resides,
• The Name for the device (which can be left empty),
• And the type of device
Figure 47 Creating an entry for FCP port map
Enter desired lun address > 1
Select Protocol (0 - SCSI, X=Cancel) > 0
Enter desired Device Name (could be empty) >
DISK_DEVICE
PRINTER_DEVICE
WORM_DEVICE
SCANNER_DEVICE
MEDIUM_CHGR_DEVICE - 8,
ARRAY_CTLR_DEVICE
Enter desired Device Type > 1
Enter device target id > 5
Enter device lun id > 0
NOTE: If the device being added is a SCSI device, the user is also asked to enter Target ID and LUN ID
for the device. Target ID must already be defined in the SCSI Configuration. Otherwise, adding a device is
not permitted.
NOTE: Select MEDIUM_CHGR_DEVICE for the library or robot controller.
NOTE: When creating a device that does not exist, it will be displayed with Down status.
72 Using the Command Line Interface
- 0, TAPE_DEVICE
- 2, PROCESSOR_DEVICE
- 4, CDROM_DEVICE
- 6, OPTICAL_DEVICE
COMM_DEVICE
- 12, ENCLOSURE_SRV_DEVICE - 13
- 1
- 3
- 5
- 7
- 9