DAELIM ROADWIN FI - CATALOG Owner's Manual page 22

Check that the fluid level is above the
LOWER level mark with the motercycle
in an upright position.
Brake fluid must be added to the reservoir
whenever the fluid level begins to reach
the LOWER level mark.
1. Remove the screws and master cylinder
cap, diaphragm plate, and diaphragm.
2. Fill the reservoir with recommended
brake fluid from a sealed container up
to the UPPER level mark.
RECOMMENDED BRAKE FLUID
is DOT3
3. Reinstall the diaphragm, diaphragm
plate, and master cylinder cap.
4. Tighten the screws securely.
Other checks :
Make sure there are no fluid leaks.
Check for deterioration or cracks in the
hose and fitting.
Check the brake pad for wear when
refilling with brake fluid.
20
[REAR BRAKE]
<REAR BRAKE FLUID LEVEL>
WARNING
Brake fluid may cause irritation.
●
Avoid contact with skin or eyes. In
case of contact, flush thoroughly with
water and call a doctor if your eyes
were exposed.
KEEP OUT OF REACH OF CHIL-
●
DREN
CAUTION
When adding brake fluid, be very
●
careful not to allow foreign materials
to enter the reserve tank.
Do not fill past upper level.
●
This can cause brake fluid to leak out
of the reserve tank.
Do not let brake fluid contact vehicle
●
parts as this damages painted areas.
If oil contacts parts, quickly clean the
fluid off using a dry cloth.
Use recommended brake fluid as
●
other types can undergo chemical
changes.