Wds Configuration Using Snmp - Cisco AP541N-A-K9 Administration Manual

Configuration Examples
Configuring the Wireless Distribution System
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide
NOTE
MyAP1 and MyAP2 must be set to the same IEEE 802.11 Mode and be transmitting on the same
channel.

WDS Configuration Using SNMP

Load the FASTPATH-WLAN-ACCESS-POINT-MIB module.
From the MIB tree, navigate to the objects in the apIfConfig table.
Walk the apIfConfigName object to view the instance ID for the first WDS link
(wlan0wds0).
The first WDS link is instance 1.
Set the value of instance 1 in the apIfConfigRemoteMac object to
00:30:AB:00:00:B0.
In the MG-Soft browser, the format for the MAC address value to set is # 0x00
0x30 0xAB 0x00 0x00 0xB0.
Set the value of instance 1 in the apIfConfigWdsSecPolicy object to WPA Personal
(3).
Set the value of instance 1 in the apIfConfigSsid object to wds-link.
Set the value of instance 1 in the apIfConfigWdsWpaPskKey object to abcdefthijk.
Some MIB browsers require that the value be entered in HEX values rather than
ASCII values.
Perform the same configuration steps on MyAP2.
8
164