Cisco AP541N-A-K9 Administration Manual page 136

6
NOTE
133
Table 33 Web Server Settings
Field Description
Enable or disable access through a Secure HTTP Server
HTTPS Server
Status (HTTPS). This setting is independent of the HTTP server status
setting.
Enable or disable access through HTTP. This setting is
HTTP Server
Status independent of the HTTPS server status setting.
Specify the port number for HTTP traffic. (The default is 80.)
HTTP Port
Specify the maximum number of HTTP and HTTPS
Maximum
Sessions connections permitted to the access point Web server that are
allowed at the same time. The permitted range is 1–10. The
number you enter affects the number of connections to the
access point Configuration Utility. It has no impact on the
number of wireless clients allowed to associate with the
access point.
Enter the number of minutes a HTTP or HTTPS session remains
Session Timeout
idle before the session is terminated. The valid range is 1–1440
minutes (24 hours).
Select this option to generate a new SSL certificate for the
Generate SSL
Certificate secure Web server. This should be done once the access point
has an IP address to ensure that the common name for the
certificate matches the IP address of the access point.
Generating a new SSL certificate restarts the secure Web
server. The secure connection will not work until the new
certificate is accepted on the browser.
Click Apply to apply the changes and to save the settings. If you disable the
protocol you are currently using to access the access point management interface,
the current connection will end and you will not be able to access the access point
by using that protocol until it is enabled.
Cisco AP 541N Dual-band Single-radio Access Point Quick Start Guide
Administration
Configuring the Web Server Settings