Table of Contents
Advertisement
6.17.3 Material guide adjustment
4
5
3
1
2
1
–
Adjust the guide element (1) height with a bolt (2). The guide
element is lifted, when tightening the bolt, and vice versa. If the
bolt (2) strikes the end of the adjustment range, the latter can be
widened by the bolt (3), loosening the plate (4) shifting to a
different position and its repeated fixing.
–
Adjust the lateral position of the guide element (1) by the bolt
loosening (5), the element shifting, and its repeated fixing.
–
Adjust the guide position in the sewing direction after loosening the
bolt (6). The rear edge of the guide element (1) should be located
in the needle hole center. After adjustment, tighten the bolt (6).
6
1
GB
33
Advertisement
Table of Contents
