Table of Contents
Advertisement
6.2
Winding the hook thread
6.3
Inserting the bobbin and threading the hook thread
12
–
Thread the thread according to the picture.
–
Insert the thread under the knife (1) and tear off by pulling in the
arrow direction (2).
–
Fix the bobbin and press the lever (3) in the direction (4).
–
Start the machine up.
–
After the thread winding, slide the thread under the knife again (1)
and tear it off.
–
Insert another bobbin immediately and press the lever (3).
Caution! Risk of injury!
Switch the main switch off and wait till the motor stops.
–
Tilt the shutter (1) up.
–
Insert the bobbin (2) with the thread end (3) oriented according to
the picture.
–
Thread the thread through the slit (4) and space (5), hook upon the
shutter (1) and fasten it under the spring (6).
–
Trim the thread ends according to the picture.
–
If the hook is located to the left of the needle, fix the bobbin and
do the threading in a similar way.
4
2
1
3
2
3
6
1
4
5
Advertisement
Table of Contents
