Preparing The Host For Installation - HP C7745NB - SureStore DLT Tape Autoloader 1/9 Service Manual

Preparing the Host for Installation

28 Preparing the Host for Installation
Remember to:
Review the contents at
information on obtaining and using backup software with the autoloader.
Ensure you have a host SCSI bus adapter card that is compatible with the
autoloader.
Install the SCSI host bus adapter card, software, and compatible drivers. Refer
to the host computer user manual and SCSI bus adapter card instructions, and
follow these general steps:
When the host is powered on, install a driver and/or software into the
host that is compatible with the autoloader. Refer to the documentation
provided with the backup software for more information on installing
software and drivers (if drivers are needed).
If the host computer is connected to a network, check with the system
administrator before turning off power.
Properly power off all peripheral devices connected to the host computer.
Power off the host.
Use proper procedures to prevent electrostatic discharge (ESD). Use wrist-
grounding straps and anti-static mats when removing internal
components.
Make sure that the host computer has a card expansion slot available.
Ensure the host SCSI bus adapter card is supported by your software
application.
Do not connect the autoloader drive to the same SCSI bus as the hard
drive because it will degrade the autoloader performance.
Refer to SCSI Cable Specifications
SCSI cable length requirements.
Check for available SCSI IDs if you are installing the autoloader onto the
same SCSI bus as other devices. You might need to change the SCSI ID
from the autoloader front panel if you think there will be an ID conflict with
other devices.
You can use HP Library & Tape Tools to identify available SCSI IDs. See
Using HP Library & Tape Tools
http://www.hp.com/go/storage
on page 116 for more information on
on page 107.
for more
Chapter 1