HP C7745NB - SureStore DLT Tape Autoloader 1/9 Service Manual page 22

Rackmounting the Autoloader
Rackmounting Overview
Install clip nuts onto
front and back rail
Secure hold-down
bar onto
mounting rail
Install mounting rails
onto rack columns
22 Installing the Autoloader into a Rack
Remember to:
Remove the cosmetic enclosure and feet if you are installing a standalone
autoloader into a rack (see
on page 20).
Here is an overview of the rackmounting procedures that are described on the
following pages.
Tighten screws on
inside edge of
mounting rails to
secure in place
Install spacer
bracket on front rack
columns
Install tray
WARNING Before you begin, lower the rack's leveler feet, and extend the
rack's anti-tip device. Failure to extend the anti-tip device could
result in personal injury or damage to the tape autoloader if the
rack tips over.
Installing a Standalone Autoloader in a Rack
Tighten screws on
front of tray to
secure tray to rack.
Install autoloader onto
Install trim
bracket and filler panel
tray
Chapter 1