Axis 24HUM Administration Manual page 77

AXIS 2400/2401 Administration Manual
-preset
Specifies the preset position, i.e. 1- 20. Note that camera source must be defined within the
command.
Specifies the camera source, i.e. 1 - 4. If this is omitted, video camera source 1 is used as
-cam
default (AXIS 2401 must be set to 1).
Specifies the zoom value of the selected camera source, i.e. 1 - 999.
-zoom
Note that this option is device dependent and is supported by Sony, Canon and Videmech
drivers only.
Specifies in which direction the selected camera source shall be moved, i.e. home, up, upleft,
-move
left, downleft, down, downright, right, upright. Note that the move home option is only
supported by the drivers Sony, Canon and Videmech.
Specifies the pan angle of the selected camera source,
-pan
i.e. -180 - 180. Note that this option is device dependent and is supported by the drivers
Sony, Canon and Videmech.
Specifies the tilt angle of the selected camera source,
-tilt
i.e. -180 - 180. Note that this option is device dependent and is supported by the drivers
Sony, Canon and Videmech.
Example 1
# This command moves camera 1 up five degrees and zooms wide.
* * * * * * :
ptz -cam 1 -zoom 1 -move up;
%
Example 2
# This command moves camera 1 to preset position 1.
* * * * * * :
ptz -preset 1 -cam 1;
%
Note:
The options must be entered in the following orde r:
-speed, -preset, -cam, -zoom, -move, -pan, -tilt
For example; ptz -tilt 10 -cam 4, will not work. You must enter, ptz -cam 4 -tilt 10.
relay
This command sets the relay on or off within the AXIS 2400/2401.
Syntax
relay [-on | -off];
Appendix H-The Programming Script
75