Axis 24HUM Administration Manual page 70

68 Appendix H-The Programming Script
-interval
Specifies the time interval between consecutive snapshots. If omitted, new snapshots are
generated without any delay.
Format:
second>
-duration
Specifies the total time for the command to run. If omitted, the buffer_start command will
be issued only once.
Format:
If you specify
interrupted by any of the commands:
-store
Specifies the number of images to be stored in the buffer. This setting will override the
duration. The maximum number of images is specified by the buffer_init command.
Example
buffer_stop
The buffer_stop command terminates the storage of snapshots to an image buffer. Until
completed, the buffer_stop command will block the execution of any subsequent commands in the
event entry. Note that the
The command is typically used together with the
Syntax
buffer_stop [-src SOURCEFILE] [-cam CAMERANUMBER]
[-interval TIME] [-duration TIME] [-store SIZE];
Options
Specifies the source file name, i.e.
-src
Specifies the camera source, i.e. 1- 4. If omitted, the default camera will be used.
-cam
-interval
Specifies the time interval between consecutive snapshots. If omitted, new snapshots will be
generated without any delay.
Format:
second>
h<hours>m<minutes>s<seconds>
.
h<hours>m<minutes>s<seconds>
-duration inf
# This command will keep loading fullsize.jpg images.
* * * * * * :
buffer_start -src fullsize.jpg -cam 3 -interval s30
-duration inf;
%
buffer_start
h<hours>m<minutes>s<seconds>
.
AXIS 2400/2401 Administration Manual
, or
fps <approximate frames per
.
, the command will continue to be executed until it is
buffer_init
command behaves differently.
buffer_start
,
halfsize.jpg fullsize.jpg
, or
fps <approximate frames per
, or
buffer_start buffer_stop
command.
or
hugesize.jpg
.
.