Axis 24HUM Administration Manual page 45

AXIS 2400/2401 Administration Manual
Before you begin:
You must assign the AXIS 2400/2401 with an IP address, as described in Assigning an IP Address, on page
13, before you can use this upgrading method.
Follow the instructions below to upgrade your video servers using AXIS ThinWizard:
1. Click the Manage Network button in the AXIS ThinWizard main menu.
2. Select a network group from the drop-down list. You can only update the servers that are
included in the selected network group.
3. All AXIS servers included in the network group appear. Click the Firmware button to start the
Upgrade Wizard.
4. Follow the instructions that are presented to you to complete the installation.
For more information about AXIS ThinWizard, refer to the Axis Website at http://www.axis.com/
Upgrading using FTP
Having obtained the upgrade software, install it into the AXIS 2400/2401 by following the
instructions below:
1. Reset the AXIS 2400/2401 by powering it off and then on again.
2. Start an FTP session and log in to the AXIS 2400/2401 as
default this is set to
3. Set FTP to binary mode using the command
4. Download the new camera server software to you AXIS 2400/2401 by using the command
2400_xxx.bin flash
This process takes 30 - 60 seconds. The LEDs will flash slowly during programming.
Note:
If you need to force a download, e.g. when rever ting to an older version of software, use the syn-
tax
put 2400_xxx.bin FLASH,
5. The AXIS 2400/2401 will report
, once the programming is complete.
OK"
Caution!
In controlled environments, flash memory upgrades provide a very safe method for updating software.
However, flash products can become damaged if the updating operation if not performed correctly.
Your dealer reserves the right to charge for repairs made nece ssary due to incorrect upgrading by the
user.
.
pass
, where xxx is the version number for the firmware.
"Transfer complete, flash programming finished
Appendix B - Updating the Software
.
bin
where xxx is the version number for the firmware.
, using the root password. By
root
43
put