Axis 24HUM Administration Manual page 27

AXIS 2400/2401 Administration Manual
The Log File
All system messages are recorded in a single log file and stored in product memory. Consequently,
the file can be used as reference for examining system events. It can also serve as a useful diagnostic
tool when attempting to resolve any problem that might occur. See also Appendix A -
Troubleshooting.
Follow the instructions below to display all Video Server messages since the last Restart of the
system:
1. Click the Video Server icon in the graphic interface.
2. Click the View Log File button. All recent commands are displayed in a separate window.
Viewing the Parameter List
The Parameter List provides a comprehensive list of all of the system parameters and their current
settings. Follow the instructions below to display the list:
1. Click the Video Sever icon in the graphic interface.
2. Click View Parameter List to display the list.
3. Click Print to print a hard copy of the displayed list to your default printer.
Emergency Actions
In certain circumstances it may become necessary to restart or return the Video Server to its
Factory Default settings, or initiate a hardware Restart of the unit. Both emergency actions can be
initiated by clicking the appropriate button on this page.
Note:
Clicking Factor y Default deletes any previously defined layout and preprogramming configura-
tions.
Reinstating the Factory Default Settings
Follow the instructions below to reinstate the factory default settings in AXIS 2400/2401:
1. Switch off the AXIS 2400/2401by disconnecting the power cord.
2. Using a suitably pointed object, press and continue to hold the Control button depressed.
Note:
The Control Button is recessed within the product casing and located between the VIDEO 3 and
VIDEO 4 input connectors on the AXIS 2400, and to the left of the VIDEO OUT connector on
the AXIS 2401.
3. While continuing to hold the Control Button depressed, reconnect the power supply cable to
the video server.
4. When the Status LED starts flashing yellow, release the Control Button for at least 2 seconds.
5. Press and continue to hold the Control Button until the Status indicator permanently displays
yellow.
Configuring the Video Server
25