Control Other Devices With The Remote - Dish Network Solo 311 User Manual

S V R
ATELLITE IDEO
Follow these instructions if you accidentally change the channel or video
input on your TV and cannot get the picture back from your satellite TV
receiver. When you press the RECOVER button as described below, the
remote control sends commands to your TV to change channels or video
inputs to try to get you back to watching satellite programming. This
procedures works only if you have accidentally changed the channel or
video input and does not recover lost satellite signal (See Chapter 5 -
Reference for troubleshooting information). Satellite Video Recovery only
works if the remote control has been set up to control the TV and/or VCR.
: You may need to press the RECOVER button up to 30 times to
Note
recover your satellite TV video.
1. Press and hold the RECOVER button until all four mode buttons light,
and then let go of the button. The SAT mode button flashes twice and
then all four mode buttons flash three times.
2. Press the RECOVER button. The TV mode button flashes once and
then all four mode buttons flash once.
: Recover will first try to tune your TV to channel 3, then channel
Note
4, and then other video inputs.
3. If you see the
Important System Information
SELECT button to close the screen. You have recovered your satellite
video.
4. If you do not see the
steps 2 and 3 until you have recovered your satellite video.
: Press any remote control button other than the RECOVER but-
Note
ton to end this procedure.
C O
ONTROL THER
R C M
EMOTE ONTROL
You can set the remote to four different modes to control the receiver or
other devices. This section explains how to set up the remote to control a
device, such as a satellite TV receiver, a TV, a VCR, a DVD player,
a tuner, or an amplifier.
To set the remote to the right mode for a device, use the remote control's
mode buttons, SAT (satellite receiver), TV, VCR (for a VCR or a DVD
player), and AUX ("auxiliary," for a DVD player, or an audio amplifier). To
change the mode, press the button for the device you want the remote to
control. The mode button flashes once to show you've set the remote to that
mode.
ECOVERY
Important System Information
D
EVICES WITH THE
ODES

Control Other Devices with the Remote

screen, press the
screen, repeat
R
EMOTE
Tip: You
program the
remote that
came with your
receiver to
control as many
as three other
devices.
Page 11