Resetting The Receiver To Factory Default Settings; Using Troubleshooting Tools - Dish Network Solo 311 User Manual

Chapter 3
Using the System
Page 52
R R
ESETTING THE
S
ETTINGS
Use these instructions if you want to reset the receiver to be the same as
when it was shipped.
Note : Resetting the receiver discards all Favorite Lists except the
and lists.
All Sub
: If you have set any locks on the receiver, and the receiver is locked,
Note
these locks will be kept. If the receiver is unlocked, any such locks will be
lost. You cannot reset the receiver to default settings to discard a password
you have forgotten. Only the Customer Service Center can reset the receiver
to bypass a receiver lock.
1. Press the MENU button.
2. Select the System Setup
3. Select the
Installation
4. Select the
Factory Defaults
message, prompting you to confirm that you want to reset the receiver.
5. Select the option to confirm the reset. The receiver resets, and then
Yes
displays the Installation and Setup
U T
SING ROUBLESHOOTING
Your receiver has diagnostic tools that a Customer Service Representative
may ask you to use if you should ever run into problems while using your
equipment. Even though these tools are quite helpful, it is recommended
that you only use them when on the phone with a DISH Network
representative.
R Y R
ESETTING OUR ECEIVER
Reset your receiver as directed by the Customer Service Representative as
follows:
1. Press and hold the front panel POWER until the green indicator blinks
once and the TV screen goes blank.
2. Let go of the front panel POWER. It will take a few minutes for your
receiver to reset and come back on. When you reset your receiver, your
receiver will download an updated
F
ECEIVER TO ACTORY
option.
option.
option.The receiver displays a
menu.
T
OOLS
Program Guide
D
EFAULT
All Chan
Warning
.