Dish Network Solo 311 User Manual page 69

Chapter 4
Reference
U E T
SING VENT IMERS
What Is Happening
You try to set up an event
timer and the receiver
displays a message noting
that the program is locked.
You try to set up an event
timer and the receiver
displays a message noting
that the program is a pay per
view event.
You try to set up an event
timer, but the receiver
displays an Error message
giving you the option to
delete an event timer that
was set up earlier.
You set up an event timer,
but the receiver does not
tune to the channel of the
program, or does not record
the program.
You set up an event timer
for a program that is
repeated (such as a regularly
scheduled program), but the
timer does not operate for a
showing of the program.
You set up an event timer,
but the timer does not
operate at all.
You set up a Once event
timer, but the timer operates
at a time different from what
you expect.
You stop the operation of an
event timer for one showing
of a program that is repeated
(such as a regularly
scheduled program), but the
timer operates for the next
showing.
You are testing a VCR code
to see if the receiver controls
a VCR.
The VCR does not do the
test.
Page 64
Possible Reason
You must enter the password before
you can create an event timer for a
locked program.
You must order a pay per view event
before you can create an event timer
for it.
You already have set up the maximum
number of event timers.
You may have set up a Reminder
Event Timer but what you should have
set up is an Auto/Ext Event Timer, or a
VCR Event Timer.
You may have set up a timer with an
incorrect frequency.
The program time may have changed
so that the event timer overlapped
another event timer.
The program time may have changed
by more than twenty-four hours.
The program time changed.
Stopping the event timer applies only
to the current showing of the program.
The VCR may not be turned ON, there
may not be a tape inserted, the tape
may not be rewound, or the write-
protect tab on the tape may have been
removed.
The code you are testing may not be
valid for the VCR.
What to Do
To be able to set up an event timer for the program, first enter the
password.
To be able to set up an event timer for the event, first order it.
To be able to set up a new event timer, delete one of the event timers
you set up earlier.
Remember that a Reminder Event Timer just reminds you that the
program is about to start. An Auto/Ext Event Timer reminds you and
tunes the receiver to the channel of the program. A VCR Event Timer
reminds you, tunes the receiver, and starts the VCR.
Remember that a Once event timer operates just one time. A Mon.-
Fri. event timer operates Monday through Friday on the same
channel at the same time. A Daily event timer does the same, Monday
through Sunday. A Weekly event timer operates once a week on the
same channel at the same time.
If the receiver is ON and finds an event timer overlap, it will display
the Event Timer Scheduling Conflict menu. You must edit or
delete one of the overlapping event timers.
No event timer will operate if the program time changes by more than
twenty-four hours.
A Once event timer always operates at the actual time of the program.
To stop all operations of a repeated event timer, you must delete the
event timer.
Note: The receiver deletes a Once event timer when it operates.
Make sure the VCR is turned ON, with a blank tape inserted on which
you want to record, that the tape is rewound, and that the write-
protect tab on the tape is intact.
Try another VCR code from the VCR Codes table. The remote
control user guide provides this table.