Dish Network Solo 311 User Manual page 17

Chapter 2
Parts of the System
Page 12
L M
IMITED ODE
You can program your remote control in limited mode to keep from accidentally
changing the channel on your TV or VCR. When you use the remote to control
your TV in limited mode, you will only be able to use the POWER, MUTE,
and VOLUME buttons. Also, when you use the remote to control your VCR in
limited mode, you will only be able to use the POWER and VCR tape control
buttons.
The section Set Up the Remote Control has a step that tells the remote control to
go into limited mode.
Note : Limited mode is not used with amplifiers.
S U R
ET P THE EMOTE
You can set up the remote to control other devices using the device codes listed
on page 65.
1. Turn the device on.
2. Find the brand name of the
device in the tables starting on
page 65.
3. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
4. For AUX mode only. Press 0
for a second TV, or 1 for a
VCR or DVD player, or 2 for
a tuner, or amplifier.
5. Enter one of the three-digit
device codes from the table
using the number buttons.
6. If you want to program
limited mode, press 1. If not
skip to step 7.
7. Press the POUND (#) button.
If you are programming a TV/
VCR or TV/DVD
combination, repeat step 3
with the remote control in
VCR mode.
C
ONTROL
Use the device's front panel buttons
or its remote control.
If the brand isn't listed, see Scan for
Device Codes on page 13.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
This step is for programming which
kind of device that should be
programmed in AUX mode. If
you're not programming in AUX
mode, skip to step 5.
The three-digit device code should
be for the brand name of your device
that you found in step 2.
See Limited Mode for more
information.
If you entered the code correctly, the
mode button flashes three times.