Resetting Receiver To Factory Default Settings - Dish Network 512 User Manual

Chapter 3
Using the System
Turning Caller ID On and Off

Resetting Receiver to Factory Default Settings

Page 82
1. Press MENU 6-1-2 on the DISH Network remote control.
2. From the Caller ID screen, select either
or the
Disable Caller ID
3. Select .
Done
: Resetting the receiver to factory-default settings discards all
Note
except the
Lists All Chan
: If you have set any locks on the receiver, and the receiver is locked, then
Note
these locks will be kept. If the receiver is unlocked, any such locks will be lost.
You cannot reset the receiver to factory-default settings to discard a password
that you have forgotten. Nobody can reset a receiver to bypass a receiver lock.
If you want to reset the DVR receiver to be the same as when it was shipped to
you from the factory, do the following:
1. Press MENU 6-6 to request the factory reset.
2. When the receiver displays a
reset all receiver preferences by selecting
Enable Caller ID
option if you wish to disable this feature.
and lists.
All Sub
message, confirm that you want to
Warning
.
Yes
(if it is disabled)
Favorites