Dish Network 512 User Manual page 35

Chapter 2
Receiver Description and Installation
Page 30
has finished testing your switch, it displays the
screen.
6. Make sure that the information on the
identifies your system correctly and shows all transponders for all satellites
in your system. Your screen may look different from the example above,
depending on the dish antenna system you are using.
7. Select to go to the
OK
8. Select to exit the Point Dish menu. An
Cancel
appear, asking you if the mounting and positioning of your dish is complete
with a indication in the
Locked
select Yes. If you answer No, you should realign the dish antenna system.
9. After you select Yes, the receiver will begin downloading and installing a
software upgrade. You will see a Warning that
will now be downloaded into your receiver
indicating the progress of this upgrade.
10. Once the download of the upgraded software is complete, you will see a
message that your receiver's memory is being upgraded with the new
software.
11. Do not disturb the receiver while the receiver's memory is being upgraded.
: If you are installing other DISH Pro or DISH Pro Plus receivers, be
Note
sure to run the
Check Switch
accept the necessary software upgrade(s).
12. When the receiver has finished upgrading its memory with the new
software, you should then be watching live video on your TV. Your dish
antenna installation is now complete.
Installation Summary
screen.
Point Dish/Signal
screen. If your answer is yes,
Point Dish
. You will also see a status bar
test on all of them, and allow each of them to
Installation Summary
screen
screen will
Attention
Vital program information