DirecTV ProScan DSS Receiver User Manual page 2

Safety Information
WARNING
To reduce risk of fire or
shock hazard, do not
expose this receiver to
rain or moisture.
Cautions
Note to Cable TV Installer:
Note to Satellite Dish Installer:
IMPORTANT NOTICE:
Care and Cleaning:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
WARNING
REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE
RISK OF ELECTRIC SHOCK
DO NOT OPEN
PERSONNEL.
This symbol indicates "dangerous
voltage" inside the product that
presents a risk of electric shock or
personal injury.
Do not stack electronic components or other objects on top of the DSS
Receiver. The slots on top of the receiver must be left uncovered to allow
proper airflow to the unit. Blocking the airflow to the unit could impair
performance or damage your receiver and other components.
Do not stack the DSS
power amplifier.
FCC Regulations state that unauthorized changes or modifications to this
equipment may void the user's authority to operate it.
The RF remote control complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) The RF remote control may not
cause harmful interference and; 2) The RF remote control must accept any
interference received, including interference that may cause undesired
operation.
This reminder is provided to call your attention to Article 820-40 of the
National Electrical Code (Section 54 of the Canadian Electrical Code, Part 1)
which provides guidelines for proper grounding and, in particular, specifies
that the cable ground shall be connected to the grounding system of the
building as close to the point of cable entry as practical.
This reminder is provided to call your attention to Article 810 and in
particular article 810-15 of the National Electrical Code which covers proper
installation and grounding of television receiving equipment as well as to
article 820-40 of the National Electrical Code which specifies that the satellite
dish cable ground shall be connected to the grounding system of the building
as close to the point of cable entry as practical.
This device incorporates an anticopy process technology that is protected by
U.S. patents and other intellectual property rights. The anticopy process is
licensed for non-commercial, home use only. Reverse engineering or
disassembly is prohibited.
Use a soft cloth or dusting attachment of your vacuum cleaner to dust your
DSS® receiver. Remove dust from the ventilation holes on the top and
bottom.
Plastic surfaces are easily scratched and can be marred by alcohol and
various solvents. Avoid excessive use of oil-based furniture polishes since the
materials used in the cabinet will accumulate more dust. A non-abrasive,
anti-static cleaner/polisher is recommended.
® receiver on top of a "hot component" such as an audio
This symbol indicates important
instructions accompanying the
product.
®