Lamp Command; Cf_Lamph Command; Cf_Lampmode Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Expand Serial Command Functional Specifications
8.8

Lamp Command

8.8.1

CF_LAMPH Command

Command "CF_LAMPH_%1"[CR]
%1 "RST"
Reset total lamp running time
Details
This command is available in normal Power ON status.
Acceptable
Correspondence
Unacceptable
8.8.2

CF_LAMPMODE Command

Command "CF_LAMPMODE_%1" [CR]
"ON" ---------------------------- Set lamp control mode to ECO
%1
"OFF" --------------------------- Set lamp control mode to NORMAL
Select Eco mode. (Valid only when in the normal Power ON status.)
The value set by this command is stored in EEPROM and the setting
Details
remains effective after the power is turned to ALL OFF status.
No display is shown when projector received command..
Acceptable
Correspondence
Unacceptable
Acceptable
Unacceptable
"000" [CR]
"Error Code" [CR]
23 / 47