PDG-DWL100 Expand Serial Command Functional Specifications
Overview
1ÿ
0û
This Functional Specification defines communication with Network board for PDG- DWL100.
0û
Commands are designed to Network communication, but most commands are also available to
remote-control a projector through RS-232C from a computer. Therefore, commands are defined as
Expand Serial Commands.
0û
The operation by some commands depends on Input or Source of the projector.
2ÿ
Serial Interface Specification
2.1 Transfer Specification
Items
Synchronous System
Transmission Speed
Data Length
Parity
Stop Bit
Flow Control
1) Transmission Speed: Initial setting value is 9600.
2) Transmission Speed can be changed in service mode.
2.2 Connection
Use the dedicated serial cables for the connection between a computer and the projector.
Connect COM port of the computer to SERIAL PORT IN of the projector.
COM Port (COM1 or COM2) of a computer is specified by the control software of the computer.
Asynchronous
9600/19200
8 bit
N/A
1
N/A
PC
COM 1
ÿ D - Sub 9 Pinÿ
6 / 47
Specification
Projector
Serial Port IN
ÿ Mini 8 Pinÿ