Pc Control Command; Cf_Fsync Command; Cf_Tdots Command; Cf_H-Pos Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Expand Serial Command Functional Specifications
8.5

PC Control Command

8.5.1

CF_FSYNC Command

Command "CF_FSYNC_%1" [CR]
"0000~0031" ----------------- Directly specify setting value of Fine sync
%1 "UP" --------------------------- Increment setting value of Fine sync by 1
"DN" --------------------------- Decrement setting value of Fine sync by 1
Set value of Fine sync in PC signal
Details (Available only in the normal Power ON status)
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable
8.5.2

CF_TDOTS Command

Command "CF_TDOTS_%1" [CR]
"-005 ~ 0005" --------------- Directly specify setting value of Total dots
%1
"UP" ------------------------- Increment setting value of Total dots by 1
"DN" ------------------------- Decrement setting value of Total dots by 1
Set value of Total Dots in PC signal
Details (Available only in the normal Power ON status)
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable
8.5.3

CF_H-POS Command

Command "CF_H-POS_%1" [CR]
"-005~0005" -------- Directly specify setting value of Horizontal Position
%1
"UP" ------------------- Increment setting value of Horizontal Position by 1
"DN" ------------------ Decrement setting value of Horizontal Position by 1
Set value of Horizontal Position in PC signal
Details (Available only in the normal Power ON status)
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable
8.5.4

CF_V-POS Command

Command "CF_V-POS_%1" [CR]
"-005~0005" ------------ Directly specify setting value of Vertical Position
%1
"UP" --------------------- Increment setting value of Vertical Position by 1
"DN" --------------------- Decrement setting value of Vertical Position by 1
Set Vertical Position value in PC signal
Details (Available only in the normal Power ON status)
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable
"000" [CR]
"Error Code" [CR]
"nnnn" indicates minimum value, which is current
(Display Dots + Position H) value
"000" [CR]
"Error Code" [CR]
"nnnn" indicates maximum value, which is current value of
(Total Dots - Display Dots)
"000" [CR]
"Error Code" [CR]
"nnnn" indicates maximum value, which is current (Total Line
– Display Line) value
"000" [CR]
"Error Code" [CR]
18 / 47