Cf_V-Pos Command; Cf_Clamp Command; Cf_Ddots Command - Sanyo PDG-DHT8000L - 8000 Lumens Specifications

PDG-DHT8000L Expand Serial Command Functional Specifications

8.5.4 CF_V-POS Command

Command "CF_V-POS_%1" [CR]
"0000-nnnn" ------------ Directly specify setting value of Vertical Position
%1
"nnnn" indicates maximum value, which is current (Total Line – Display Area V) value
"UP" --------------------- Increment setting value of Vertical Position by 1
"DN" --------------------- Decrement setting value of Vertical Position by 1
Set Vertical Position value in PC signal (Available only in the normal Power ON
status). The value set by this command is not stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.5.5 CF_CLAMP Command

Command "CF_CLAMP_%1" [CR]
"0000-4095" ----------- Directly specify setting value of Clamp
%1 "UP" --------------------- Increment setting value of Clamp by 1
"DN" --------------------- Decrement setting value of Clamp by 1
Set Clamp value in PC signal. (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF stasis, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.5.6 CF_DDOTS Command

Command "CF_DDOTS_%1" [CR]
"0256-nnnn" ----------------- Directly specify setting value of Display Dots
%1 H).In this projector, the value should be "even number" and if "odd number" is specified, it
adds 1 to make the value even number.
"UP" ------------------- Increment setting value of Display Dots by 2
"DN" ------------------- Decrement setting value of Display Dots by 2
Set Display Dots value in PC signal. (Available only in the normal Power ON
status). The value set by this command is not stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"nnnn" indicates maximum value, which is current value of (Total Dots - Position H).
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
28/101