Lamp Status Read Commands; Cr_Lamprepl Command; Cr_Lampmode Command; Cr_Autolampcontrl Command - Sanyo PDG-DHT8000L - 8000 Lumens Specifications

PDG-DHT8000L Expand Serial Command Functional Specifications

9.9 Lamp Status Read Commands

9.9.1 CR_LAMPREPL Command

Command "CR_LAMPREPL" [CR]
Details Get the information of Lamp Replacement time
Acceptable
Response
%1
Unacceptable

9.9.2 CR_LAMPMODE Command

Command "CR_LAMPMODE" [CR]
Details Get Lamp mode setting status
Acceptable
Response
%1
Unacceptable

9.9.3 CR_AUTOLAMPCONTRL Command

Command "CR_AUTOLAMPCONTRL" [CR]
Details Get selected Lamp control mode
Acceptable
Response
%1
Unacceptable

9.9.4 CR_LAMPSTS Command

Command "CR_LAMPSTS" [CR]
Details Get the information of Lamp lighting status
Acceptable
Response
%1
Unacceptable
"000_%1" [CR]
"2**"
2 ---------------- indicates 2 lamps are used in this model.
* ---------------- indicates the status of each lamp in lamp number
order.
"Y" means the lamp operating time is over the
threshold for lamp replacement, and "N" means
it has not reached to.
e.g.
"2YN" ------------ This indicates it is 2-lamp system, and Lamp #2
has not been reached to the replacement time
while #1 should be replaced.
"?" [CR]
"000_%1" [CR]
"FULL" ---------------- Lamp mode is set to 2-lamp (FULL)
"LAMP1"-------------- Lamp mode is set to Lamp1
"LAMP2" ------------- Lamp mode is set to Lamp2
"?" [CR]
"000_%1" [CR]
"NORMAL" ---------- NORMAL is selected.
"ECO1" --------------- ECO1 is selected.
"ECO2" --------------- ECO2 is selected.
"Error Code" [CR]
"000_%1" [CR]
"2**"
The first character indicates 2 lamps are used in this model.
The following characters indicate each lamp status in lamp
number order as showed below.
"I" ------------------------ Lamp is ON
"O" ---------------------- Lamp is OFF
"X" ----------------------- Lamp Failure
e.g.
"2IO" ------------------- This indicates it is 2-lamps system, Lamp
#1 is ON, and #2 is OFF.
"?" [CR]
78/101