Cf_Dline Command; Cf_Setpcadj Command; Cf_Orgmode Command - Sanyo PDG-DHT8000L - 8000 Lumens Specifications

PDG-DHT8000L Expand Serial Command Functional Specifications

8.5.7 CF_DLINE Command

Command "CF_DLINE_%1" [CR]
"0100-nnnn" ----------- Directly specify setting value of Display Line
%1
"UP" ------------------- Increment setting value of Display Line by 1
"DN" ------------------- Decrement setting value of Display line by 1
Set setting value of Display Line in PC signal (Available only in the normal Power
ON status). The value set by this command is not being stored in the projector's
Details
memory. Therefore, when the power is turned to ALL OFF status, the value
returns to the original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.5.8 CF_SETPCADJ Command

Command "CF_SETPCADJ_%1" [CR]
"XGA1", "HDTV1080", "MODE1" ....................................Etc.
%1
"EXT11"~"EXT60"
Note1) When "XGA","HDTV1080","MODE1" is specified in %1, the command is not
executed.
Detail
Note2) When "EXTn-EXTnn" (nn represents number) is specified in %1, "EXT" is
displayed in "SYSTEM" menu (only when Network board is provided).
Acceptable
Response
Unacceptable

8.5.9 CF_ORGMODE Command

Command "CF_ORGMODE_%1" [CR]
When input signal is PC Analog;
"VGA1" ------------------------ Specify VGA1
:
"WXGA3" --------------------- Specify WXGA3
"1080I60" --------------------- Specify 1080i60
"1080I50" --------------------- Specify 1080i50
"1035I" ------------------------ Specify 10350i
"720p60" --------------------- Specify 720p60
"720p50" --------------------- Specify 720p50
"575p" ------------------------- Specify 575p
%1
"480p" ------------------------- Specify 480p
"575I" -------------------------- Specify 575i
"480I" -------------------------- Specify 480i
"1080psf/24" ----------------- Specify 1080psf/24
"1080psf/25" ----------------- Specify 1080psf/25
"1080psf/30" ----------------- Specify 1080psf/30
"1080p24" -------------------- Specify 1080p24
:
"1080p60" -------------------- Specify 1080p60
* When input signal is not PC Analog, error code "101" is returned.
After "EXT n" is set by PC control command such as CF_FSYNC/CF_TDOTS and
CF_SETPCADJ command, specify the signal originated with by issuing this
command.
Details This command is used to specify projector internal settings such as whether or not
to get PC signal through IP (Available only in the normal Power ON status)
Note; To differentiate between 60Hz and 50Hz in 1080i and 720p, "60" or "50" is
necessary to add to the parameter in this command.
Acceptable
Response
Unacceptable
"nnnn" indicates maximum value, which is current value of (Total Line - Position V).
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
"000" [CR]
"101" [CR] --- When input is Video signal
29/101