Functional Execution Command; Format; Transfer Example; Operation Requirements - Sanyo PDG-DHT8000L - 8000 Lumens Specifications

PDG-DHT8000L Expand Serial Command Functional Specifications

Functional Execution Command

8ÿ

8.1 Format

1) PC issues a command in the format below:
Pattern1: "CF_Command" [CR]
Pattern2: "CF_Command_" %1 [CR]
2) The projector decodes the received command and when it gets ready to receive another
command, it returns the response.
"000" [CR]: (0x06, 0x0D) When receiving Functional Execution Command
"nnn" [CR]: Except "000", when it cannot execute commands for any specific reason.
"?" [CR]: When the received data cannot be decoded

8.2 Transfer Example

When setting projector's total dots to 1344 by Expand Command.
PC → PJ: "CF_TDOTS_1344" [CR]
PC ← PJ: "000" [CR] ---------------- Acceptable

8.3 Operation Requirements

When the projector status is in the status below, Functional Execution Commands are limited
(Status Read Commands are available in following status)
Projector Status
In Standby status
Count Down in process
Cooling Down in process
Cooling Down
abnormal temperature
In Abnormal Temperature
Power Failure
(60 seconds after Power failed)
Power Saving Cooling Down in process
In Power Saving status
Note) An appropriate error code is returned when the projector receives other command in the
above status.
CF_: Header
Command: String
%1: Parameter (String)
_: Space (To separate Command and Parameter)
For detail, refer to [7. Error Code Table]
Available Functional Execution Command
C00: POWER ON
C00: POWER ON (Countdown is terminated)
NONE (No Execution)
in process due to
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
C00: POWER ON
C01: POWER OFF
21/101