Installing The Hardware - Juniper NETWORK AND SECURITY MANAGER NSMXPRESS - QUICK START REV1 Quick Start Manual

Installing the Hardware

Copyright © 2010, Juniper Networks, Inc.
Table 1: Required Ports on NSMXpress (continued)
Direction Port Description
Out 22 SSH connection to new managed
device
23 Telnet connection to new
managed device
53 DNS lookups
80 System Security Updates from
Juniper Networks
111 Shared Disk portmap lookup
123 Network Time Protocol (NTP) time
synchronization
2049 Shared Disk NFS connection
For more information on ports, refer to the Network and Security Manager Installation
Guide.
Follow these steps to unpack the NSMXpress appliance and connect it to your network.
To install NSMXpress:
Place the shipping container on a flat surface and remove the hardware components
1.
with care.
Remove the NSMXpress device from the shipping container and place it on a flat
2.
surface.
Mount NSMXpress in your server rack using the attached mounting brackets.
3.
Plug the power cord into the AC receptacle on the rear panel.
4.
If your NSMXpress contains two power supplies, plug a power cord into each AC
receptacle.
Plug the other end of the power cord into a wall socket.
5.
If your NSMXpress contains two power supplies, plug each power cord into a separate
power circuit to ensure that the NSMXpress continues to receive power if one of the
power circuits fails.
Plug the Ethernet cable into the port marked ETH0 on the front panel. See Figure 1 on
6.
page 6.
Hardware Installation
Depends on
LAN Internet Configuration
Yes Yes No
Yes No Yes
Yes No No
No Yes Yes
Yes No Yes
Yes Yes Yes
Yes No Yes
5