Adding And Configuring Syslog Receivers - Juniper NETWORK AND SECURITY MANAGER NSMXPRESS - QUICK START REV1 Quick Start Manual

NSMXpress Quick Start
32
View the configured syslog receivers in the table in the top portion of the window.
2.
Table 3 on page 32 describes the fields.
Table 3: Viewing Syslog Receivers
Field
Receiver
IP Address
Type
Data sources
System
Device Server
GUI Server
HA Server

Adding and Configuring Syslog Receivers

To add and configure a syslog receiver, follow these steps:
Select System Administration > Syslog Forwarding.
1.
In the Data Sources section, select the syslog facility for each GUI Server log, Device
2.
Server log, and HA Server log. The syslog facility is a field included in the syslog
message to help identify the data source.
Click Save.
3.
Click Add new Receiver.
4.
The syslog receiver configuration window appears as shown in Figure 35 on page 33.
Description
A name provided by the network administrator to identify the syslog
receiver
The IP address of the syslog receiver
The protocol used for forwarding messages: UDP, TCP, SSL
The data sources configured for forwarding
The system logs configured to be sent to this receiver.
The Device Server logs configured to be sent to this receiver.
The GUI Server logs configured to be sent to this receiver.
The HA Server logs configured to be sent to this receiver.
Copyright © 2010, Juniper Networks, Inc.