Table of Contents
Advertisement
RADIUS
System
Copyright © 2010, Juniper Networks, Inc.
Inclusion of RADIUS IETF Framed-Route Attribute [22] in RADIUS Accounting
Messages
You can now specify that RADIUS accounting messages include the RADIUS IETF
Framed-Route attribute [22]. You can use the radius include command from Global
Configuration mode to configure inclusion of this RADIUS attribute in Acct-Start,
Acct-Stop, and Interim-Acct messages. When included in Acct-Stop messages, the
attribute is also included in Interim-Acct messages. The attribute is excluded by
default from the Acct-Start, Acct-Stop, and Interim-Acct messages.
As a part of this feature, the framed-route keyword has been added to the radius
include command.
The following command has been modified to support this feature:
radius include
The output of the following command has been modified to support this feature:
show radius attribute-included
Change in existing behavior: New feature added as described here.
Support for Conventional Upgrade on ES2 10G LMs
JunosE Software now supports field programmable gate array (FPGA) upgrades on
REV-02 ES2 10G line modules. You must perform the upgrade using a conventional
software upgrade process; you cannot use the unified ISSU process to perform the
upgrade. In lower-numbered releases, you were not able to use a conventional
software upgrade or a unified ISSU process on REV-02 ES2 10G LMs.
In this release, design enhancements enable you to perform a stateless upgrade
(non-unified ISSU method, with router-wide outage for users) from JunosE releases
numbered lower than Release 11.3.0 to JunosE Release 11.3.0. You cannot run a
unified ISSU procedure from JunosE releases that do not contain the design changes
for control and status register (CSR) FPGA functionality if the router chassis contains
ES2 10G LMs or REV-02 ES2 10G LMs.
The following design improvements to FPGA have been made in this release:
FPGA modifications for resolving fabric-related problems related to SFM
redundancy on ES2 4G LMs, ES2 10G LMs, ES2 10G ADV LMs, SRP-100, and
SRP-320 modules
CSR FPGA changes on ES2 10G LMs and REV-02 ES2 10G LMs to enable FPGA
upgrades
If your network contains routers installed with LMs other than ES2 10G LMs or
REV-02 ES2 10G LMs, a preferred suggestion is to transfer subscribers configured on
the ES2 10G LMs or REV-02 10G LMs to other LMs available in your environment
when you perform unified ISSU. This transfer of subcribers to other LMs avoids
disruption of user sessions owing to the limitation that exists with performing a
unified ISSU operation on ES2 10 LMs and REV-02 10G LMs.
Release 11.3.0
Release Highlights
9
Advertisement
Table of Contents
