Hardware Compliance; Federal Communications Commission (Fcc) Statement; Fcc Requirements For Consumer Products - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 HARDWARE GUIDE REV 9-29-2010 Hardware Manual

Hardware Compliance

Federal Communications Commission (FCC) Statement

FCC Requirements for Consumer Products

Copyright © 2010, Juniper Networks, Inc.
In accordance with Article 11(2) of Directive 2002/96/EC (WEEE), products put on the
market after 13 August 2005 are marked with the following symbol or include it in their
documentation: a crossed-out wheeled waste bin with a bar beneath.
Juniper Networks provides recycling support for our equipment worldwide to comply
with the WEEE Directive. For recycling information, go to
http://www.juniper.net/environmental
equipment that you wish to dispose of and the country where it is currently located, or
contact your Juniper Networks account representative.
Products returned through our reclamation process are recycled, recovered, or disposed
of in a responsible manner. Our packaging is designed to be recycled and should be
handled in accordance with your local recycling policies.
The router meets the hardware compliance requirements in this section.
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This equipment is designed for use with properly shielded and terminated cables. Refer
to the installation sections of this manual before operation.
Reference: CFR 47, Part 15J, Sect 15.105 April 18, 1989
Caution: Changes or Modifications to this equipment not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This equipment complies with FCC rules, Part 68. On the back side of this equipment is
a label that contains, among other information, the FCC Registration Number and Ringer
Appendix B: Installation Guidelines and Requirements
, and indicate the type of Juniper Networks
101