Table of Contents
Advertisement
E120 and E320 11.3.x Hardware Guide
22
WARNING: Two people are required to lift the router.
CAUTION: To prevent electrostatic damage to the system and its
components, make sure persons handling the router wear an antistatic device.
Connectors are located on the IOAs, SRP IOA, and the power distribution unit (PDU).
These modules are installed from the rear of the router (Figure 10 on page 22 and Figure
11 on page 23). See "Cabling the Router" on page 45 for cabling installation procedures.
Figure 10: E320 Router, Rear View
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 HARDWARE GUIDE REV 9-29-2010
Related Products for Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 HARDWARE GUIDE REV 9-29-2010
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 MODULE GUIDE REV 01-10-2010
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX MODULE GUIDE REV 27-9-2010
- Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - ERX HARDWARE GUIDE REV 26-9-2010
- Juniper TX Matrix RE-600
- Juniper TX Matrix RE-1600
- Juniper TX Matrix RE-2000
- Juniper NETWORKS STRM - TECHNICAL NOTE REV 6-2008
- Juniper JUNOS - NETWORK OPERATION GUIDE REV1