Troubleshooting - Tanita SC-330ST Instruction Manual

Troubleshooting

GB
- Please check the following before asking for repair.
Symptom
Impedance
measurement error
How to
Zero point error
measure
The measured
weight is not stable.
Nothing is
displayed even after
turning on the
Display
power.
part
displayed.
42
Please check
•Measure with bare feet.
•When the soles of your feet are dry, drop
water for about 0.5 ml with the attached
dropper on the electrodes before
measurement.
•Check the input information.
•Turn off the power, and remove the items on
the platform and turn on the power again, and
then redo the measurement.
•Is it installed at a place with vibrations?
•Is the platform inclined?
e Keep the platform horizontal. (
and 7)
•Is anything caught in the gaps of the
platform?
e Remove anything caught in the gaps.
•Check that the power supply is connected
correctly.
is
•The weight to measure exceeds the
measurement range.
Symptom
Run out of print paper
Printer cover open
Printer
Paper does not come
out.
pages 6
The paper comes
out, however,
nothing has been
printed.
Note
• In the case that an error is displayed other than the above, turn off the power once, and then measure
again.
If the same error is displayed repeatedly, contact our customer service centre.
Please check
•Print paper is not supplied.
e Supply paper.
e In the case that the printer is not used, press
and redo the initial setting.
CE
•The printer cover is open.
e Properly close it.
e Check that the print paper is not slanted.
Check the settings.
•Is 0 set for the number of sheets to print in the
"determination of the number of sheets to
print?"
e Press 1 – 3. ( page 13)
•The printer may be broken.
e Contact the agent from which you have
purchased the product.
•Is the reverse side of the print paper set?
e Set the paper properly. ( page 9)
•The printer may be broken.
e Contact the agent from which you have
purchased the product.
GB
43