Preparation - Tanita SC-330ST Instruction Manual

GB
Control panel
Connection of Plugs
Rear side of the
controller
•To avoid electric shock, do not insert or remove the plug with wet
hands.
•To avoid electric shock, do not use the equipment near water.
• To avoid measurement error, do not measure while using equipment that generates
radio waves, such as mobile phones.
• Use only the original AC adapter (MODEL: SA165-0950U-3). Using AC adapters
other than the original one may cause malfunction, smoke or fire.
Symbols and their Meanings
Power On Power Off
Caution
Advances the
Refer to the
paper
attached notes.
8
AC adapter
Class II
Direct current Input, Output
Equipment
Clothes Weight
Male Female
Setting

Preparation

• Please change the paper roll when red lines appear along the sides of the paper.
• Please pay careful attention to avoid injury from the sharp edge.
• Please turn off the machine before clearing Paper jams.
Setting of the printer paper
1 Press to turn on the power.
• After all lamps light up, the model number is displayed as
and is displayed.
2 (1) Press .
OPEN
(2) Remove the printer cover.
(3) Set up the printer paper
3
• Remove the adhesive of the printer paper and draw it
out approx. 10 cm / 3 inch.
Return the printer cover.
4
• In the case that is displayed,
e The printer cover is open, so please close it
again properly ( page 43).
Press the , and cut off the
5
FEED
excessive paper.
• In the case that the automatic cutting is set to
"OFF," the automatic cutting does not function
( page 14).
Setting completed.
6
Setting of the printer paper
,
GB
9