Lan Setup - Static Ip - D-Link DHP-W306AV User Manual

Section 3 - Configuration
Select Static IP to manually enter the IP address, subnet mask, and default gateway addresses.
LAN Connection
Select Static IP from the drop-down menu.
Type:
IP Address:
Enter the IP address of the access point. The
default IP address is 192.168.0.50. If you change
the IP address, once you click Apply, you will
need to enter the new IP address in your
browser to return to the configuration
utility.
Subnet Mask:
Enter the Subnet Mask.
Default Gateway:
Enter the Gateway. This is usually the LAN or
internal IP address of your router.
Device Name:
Enter the Device Name of the AP. It is
recommended that you change the Device
Name if there is more than one D-Link device
within the subnet. You can enter the device
name of the AP into your web browser to access
it instead of IP address for configuration. If you
are using the device name to connect, make
sure that your PC and your DHP-W306AV are
on the same network.
Save Settings:
Click Save Settings to save and activate the
new changes.
D-Link DHP-W306AV User Manual

LAN Setup - Static IP

24