Cli Examples - Dell PowerConnect M6348 Configuration Manual

External routes are those imported into OSPF from other routing protocol or processes. OSPF computes
the path cost differently for external type 1 and external type 2 routes. The cost of an external type 1
route is the cost advertised in the external LSA plus the path cost from the calculating router to the
ASBR. The cost of an external type 2 route is the cost advertised by the ASBR in its external LSA.
NOTE:
The following example uses the CLI to configure OSPF. You can also use the Web interface. Click Routing >
OSPF or IPv6 > OSPFv3 in the navigation tree.

CLI Examples

Example 1: Configuring an OSPF Border Router and Setting Interface Costs
The following example shows you how to configure an OSPF border router areas and interfaces in the
switch.
Figure 4-3. OSPF Example Network Diagram: Border Router
VLAN 80
192.150.3.1
IPv4 (OSPFv2)
• Enable routing for the switch:
console#config
ip routing
exit
76
Routing Configuration
VLAN 50
192.150.2.1
VLAN 70
192.150.2.2
VLAN 90
192.150.4.1
IPv6 (OSPFv3)
console#config
ipv6 unicast-routing
exit