Dell PowerConnect M6348 Configuration Manual page 112

Example #7: Setup an ACL with Permit Action
console# Config
console(config)#mac access-list extended mac2
console(config-mac-access-list)#permit ?
any
<srcmac>
console(config-mac-access-list)#permit any ?
any
bpdu
<dstmac>
console(config-mac-access-list)#permit any any ?
assign-queue
cos
log
mirror
redirect
vlan
<0x0600-0xffff> Enter a four-digit hexadecimal number in the range of
<cr>
<ethertypekey>
console(config-mac-access-list)#permit any any
Example #8: Show MAC Access Lists
console#show mac access-lists
Current number of all ACLs: 3
MAC ACL Name
------------------------------- ----- ------------------------- ---------
mac1
mac2
console#show mac access-lists mac1
112
Device Security
Configure a match condition for all the source MAC
addresses in the Source MAC Address field.
Enter a MAC Address.
Configure a match condition for all the destination
MAC addresses in the Destination MAC Address field.
Match on any BPDU destination MAC Address.
Enter a MAC Address.
Configure the Queue Id assignment attribute.
Configure a match condition based on a COS value.
Configure logging for this access list rule.
Configure the packet mirroring attribute.
Configure the packet redirection attribute.
Configure a match condition based on a VLAN ID.
0x0600 to 0xffff to specify a custom Ethertype value.
Press enter to execute the command.
Enter one of the following keywords to specify an
Ethertype (appletalk, arp, ibmsna, ipv4, ipv6, ipx,
mplsmcast, mplsucast, netbios, novell, pppoe, rarp).
Maximum number of all ACLs: 100
Rules
1
1
Interface(s)
1/g5
Direction
Inbound