Connecting Devices In A Stack - Dell PowerConnect B-FCX624 Hardware Installation Manual

FIGURE 20
3. Install retainer nuts into the non-threaded holes. And use 10-32 screws to fasten brackets into
FIGURE 21
4. If installing a single switch only, proceed to
5. If installing multiple switches, mount them in the rack, one below the other, in any order.

Connecting devices in a stack

PowerConnect B-FCX624s and PowerConnect B-FCX648s devices
Figure 5
based on 10G/16G Gigabit Ethernet, using CX4 cables. PowerConnect B-FCX devices support
linear and ring stack topologies, and can also operate as standalone devices.
PowerConnect B-FCX Switch Hardware Installation Guide
53-1002267-01
Attaching the brackets for PowerConnect B-FCX624 and PowerConnect B-FCX648
the rack. Attach the device in the rack as illustrated in
Installing the device in a rack
shows how the stack cables are connected between switches in a stack. The connection is
Preparing the installation site
Figure 21.
"Powering on the system"
2
on page 24.
21