Testing Connectivity; Pinging An Ip Address; Observing Leds - Dell PowerConnect B-FCX624 Hardware Installation Manual

Cleaning the fiber optic connectors
To avoid problems with the connection between the fiber optic transceiver (SFP, SFP+, or
mini-GBIC) and the fiber cable connectors.
When not using an SFP connector, make sure to keep the protective covering in place.

Testing connectivity

Test for connectivity by observing the LEDs related to network connection.

Pinging an IP address

To verify that a PowerConnect B-FCX device can reach another device through the network, enter a
command similar to the following at any level of the CLI.
PowerConnect> ping 192.33.4.7
Syntax: ping <ip addr> [source <ip addr>] [count <num>] [timeout <msec>] [ttl <num>] [verify]
NOTE
If you address the ping to the IP broadcast address, the device lists the first four responses.

Observing LEDs

After you install the network cables, you can observe certain LEDs to determine if the network
connections are functioning properly.
connections, the desired state of each LED, possible abnormal states of each LED, and what to do
if an LED indicates an abnormal state.
PowerConnect B-FCX Switch Hardware Installation Guide
53-1002267-01
[no-fragment] [quiet] [data <1-to-4 byte hex#, e.g. abcdef00>] [numeric] [size <byte>]
[brief [max-print-per-sec <num 0-2047>]]
Table 19 outlines the LEDs related to the network
Testing connectivity
3
43