Dell PowerConnect B-FCX624 Hardware Installation Manual page 20

1
Hardware features
TABLE 8
LED
PS1
PS2
(Power Supply
Status)
Diag
(Diagnostic)
A or S
(Active or Standby)
Up Link or Down
Link (Stacking
uplink or downlink
port status)
Stack ID (1-8)
FIGURE 12
1
TABLE 9
LED
DC OK
AC OK
10
System status LEDs
Condition
Green
Amber
Off
Flashing Green
Green
Amber
Green
Amber
Off
Green
Off
Green
Power status LEDs
Power status LEDs
Power status LEDs
Condition
Green
Red
Green
Off
Status
Power supply is operating normally.
Power supply fault.
Power off or failure.
System self-diagnostic test in progress.
System self-diagnostic test successfully completed.
System self-diagnostic test has detected a fault. (Blower, thermal or any
interface fault.)
The device is the Active controller. If this LED is flashing green, the
system is initializing.
Indicates the device is the Standby controller.
Device is operating as a stack member, or is in standalone mode.
Uplink is operating normally.
Uplink has failed or there is no link.
Indicates the device stack ID.
1
Status
DC output ok
DC output fail
AC input ok
AC input fail
PowerConnect B-FCX Switch Hardware Installation Guide
53-1002267-01